I’ve always been an environmentally acutely aware particular person and as such have always made some try to keep my household eco-friendly. I’ve used compost heaps and recycled my plastics, papers and aluminums, but it wasn’t until not too long ago that I decided to make an effort to attempt to save water.

I wasn’t quite certain what method I wished to strive with the intention to minimize my enamel on water conservation so I did some research online first. I discovered low-flow showerheads, HET bathrooms, tips about how you can check varied taps and bathrooms for leaks, and even options on numerous heavy items to position in my bathroom tank, so as to displace water and use less per flush. The showerheads looked interesting at first, but then I stumbled onto something called a dual flush toilet. These dual flush systems, the place one lever flushes a full tank and one lever flushes half a tank, caught my imagination. They’re unique, and in my opinion add a certain quantity of fashion to your bathroom.

At first I believed I would have to exchange my entire toilet. I consider myself fairly helpful however I am no plumber. I additionally had no intention of paying someone to tear my toilet apart. That was once I stumbled across something called a dual flush toilet retrofit kit. These kits are quite cheap and I really had no problem putting in one. I am going to depart it as much as you to find a kit you want to install, however the following are the steps I took to put in my own dual flush kit, and for those who would like to try it yourself, they are going to hopefully be quite simple to follow.

1. Turn off the water supply to the toilet and drain tank. Use a sponge to remove the excess remaining water from the tank.

2. Disconnect the tank’s inlet fitting from the water supply. Unscrew the 2 bolts that hold the tank down to the toilet.

3. Disconnect the flush deal with from the tank. Lay the tank down on a towel and, using a channel-locking plier, unscrew the big flush valve holding nut.

4. Set up the twin flush toilet kit valve — the tapered rubber gasket goes on the inside of the tank to forestall leakage. Tighten giant nut until secure.

5. Install the 2 rubber gasket tie-down bolts and their lock nuts to the bottom of the tank. Bolt the tank down to the bathroom utilizing the second set of rubber gaskets and nuts. At this stage I recommend using utterly new tank tie down bolts. They are cheap to buy at any hardware store.

6. Assemble the new arms as per required length between the handles and the new flush valve. Chances are you’ll minimize them with a hacknoticed if mandatory here.

7a) Insert the small and large handles into the handle-gap in the tank. Insert spacer if needed.

b) Hook long arm into overflow tube, and brief arm into release pole.

c) Slide short and long arms into place on the handles and use clip to secure.

d) Connect the refill tube from the fill valve to the nipple on the long arm.

8. Open water supply to the tank. Fill slowly while checking for leaks. You may want to label the large and small handles as «full» and «half», but that is personal preference.

The way my dual flush kit works I flush my full six-liter tank with the massive handle, and the small handle offers me a 4-liter flush. I haven’t got any problem with the four-liter flush efficiency and I’m quite satisfied with the way everything turned out. You possibly can imagine that folks often have something to say after they emerge from my lavatory, which always offers me a chuckle.

In the event you loved this article and you want to receive much more information with regards to قیمت فلاش تانک توکار kindly visit our own web-site.

Похожие статьи